LB22

New!

This light bar contains 21 high power dual intensity LEDs.
 In running light mode the LEDs sequence from side to
 side in a "Knight Rider" sequence. 
When the brake is applied the LED will flash 
for approximately 5-6 seconds then go to a solid 
on state until the brake is released. 
Both modes, running and brake, have been designed 
to create the maximum visibility. 
The unit comes pre-taped with 3M double sided tape for easy 
mounting to any flat surface. 
Simply connect the black wire to any ground wire, 
the Red wire to your existing brake light wire and
 the blue wire to an existing running light power source. 
Works with any 12VDC system,  load equalizer
 or resistors NOT REQUIRED.  

Dimensions: 7.5" long x .7" wide x .7" high.