.jpg)
You have no items in your shopping cart.
$29.95
This light bar contains 12 high power dual intensity LEDs.
In running light mode the LEDs sequence from side to side
in a "Knight Rider" sequence.
When the brake is applied the LED will flash for approximately
5-6 seconds then go to a solid on state until the
brake is released.
Both modes, running and brake, have been designed to
create the maximum visibility.
The unit comes pre-taped with 3M double sided tape for
easy mounting to any flat surface.
Simply connect the black wire to any ground wire,
the Red wire to your existing brake light wire
and the blue wire to an existing running light power source.
Works with any 12VDC system, no load equalizer or
resistors required.
Dimensions: 4.7" long x .7" wide x .7" high.
In running light mode the LEDs sequence from side to side
in a "Knight Rider" sequence.
When the brake is applied the LED will flash for approximately
5-6 seconds then go to a solid on state until the
brake is released.
Both modes, running and brake, have been designed to
create the maximum visibility.
The unit comes pre-taped with 3M double sided tape for
easy mounting to any flat surface.
Simply connect the black wire to any ground wire,
the Red wire to your existing brake light wire
and the blue wire to an existing running light power source.
Works with any 12VDC system, no load equalizer or
resistors required.
Dimensions: 4.7" long x .7" wide x .7" high.
